Skip navigation links
17.4.4 Connector/MXJ Configuration »
Section Navigation      [Toggle]

17.4.3.6. Verifying Installation using JUnit

[+/-]

17.4.3.6.1. JUnit Test Requirements
17.4.3.6.2. Running the JUnit Tests

The best way to ensure that your platform is supported is to run the JUnit tests. These will test the Connector/MXJ classes and the associated components.

17.4.3.6.1. JUnit Test Requirements

The first thing to do is make sure that the components will work on the platform. The MysqldResource class is really a wrapper for a native version of MySQL, so not all platforms are supported. At the time of this writing, Linux on the i386 architecture has been tested and seems to work quite well, as does OS X v10.3. There has been limited testing on Windows and Solaris.

Requirements:

  1. JDK-1.4 or newer (or the JRE if you aren't going to be compiling the source or JSPs).

  2. MySQL Connector/J version 5.0 or newer (from http://dev.mysql.com/downloads/connector/j/) installed and available via your CLASSPATH.

  3. The javax.management classes for JMX version 1.2.1, these are present in the following application servers:

  4. JUnit 3.8.1 (from http://www.junit.org/).

If building from source, All of the requirements from above, plus:

  1. Ant version 1.5 or newer (download from http://ant.apache.org/).

17.4.3.6.2. Running the JUnit Tests

  1. The tests attempt to launch MySQL on the port 3336. If you have a MySQL running, it may conflict, but this isn't very likely because the default port for MySQL is 3306. However, You may set the "c-mxj_test_port" Java property to a port of your choosing. Alternatively, you may wish to start by shutting down any instances of MySQL you have running on the target machine.

    The tests suppress output to the console by default. For verbose output, you may set the "c-mxj_test_silent" Java property to "false".

  2. To run the JUnit test suite, the $CLASSPATH must include the following:

    • JUnit

    • JMX

    • Connector/J

    • MySQL Connector/MXJ

  3. If connector-mxj.jar is not present in your download, unzip MySQL Connector/MXJ source archive. 

    cd mysqldjmx
ant dist

    Then add $TEMP/cmxj/stage/connector-mxj/connector-mxj.jar to the CLASSPATH.

  4. If you have junit, execute the unit tests. From the command line, type: 

    java com.mysql.management.AllTestsSuite

    The output should look something like this: 

    .........................................
.........................................
..........
Time: 259.438

OK (101 tests)

    Note that the tests are a bit slow near the end, so please be patient.